Adygil Fishing Jigging Lure Mold Kits 1.5oz, 2oz, 3oz, 3.5oz, 4 Cavities, 121pcs/pack,Without Handle

By A Mystery Man Writer

How to make sinkers and jigs: 1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead. 2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees). 3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top. 4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould. 5.

Adygil DIY Fishing 80pcs S/S Wire for 121pcs Jig Lure Mould Combo

JUST HEAT AND POUR Sample Set Contains One Pack of Each Color Listed Above. X-cubes from FUSION X FISHING are pre-mixed plastisol cubes used for

PLASTISOL Fishing Lure Making Plastic Cubes - Starter KIT 6 Pack - Over 16 oz (1 Pint) Total Resin

Dimatteo Fishing No Roll Sinker Mold Kits 1oz 1.5oz

PLASTISOL Fishing Lure Making Plastic Cubes - Starter KIT 6 Pack

JUST HEAT AND POUR Sample Set Contains One Pack of Each Color Listed Above. X-cubes from FUSION X FISHING are pre-mixed plastisol cubes used for

PLASTISOL Fishing Lure Making Plastic Cubes - Starter KIT 6 Pack - Over 16 oz (1 Pint) Total Resin

Round Sinker Mold With 6 Cavities and 3-Once How to make sinkers: 1. Ensure you are wearing protective clothing and all care must be taken when

Adygil Round Sinker Mold with 6 Cavities and 2-Ounce,Without Handle

Adygil Round Sinker Mold with 7 Cavities and 3/4-Ounce,Without

Adygil DIY Fishing 80pcs S/S Wire for 121pcs Jig Lure Mould Combo

Adygil Round Sinker Mold with 6 Cavities and 2-Ounce,Without